PLEXTOR PX M402U DRIVER FOR WINDOWS MAC

Another cool way to narrow down the information for any capture device and to show inputs and outputs Please contribute by registering your email address and adding your knowledge to this page. When I do I will come back here and correct the error. Open KMPlayer and direct it to play from file: You might notice that sound lags behind the video depending on your hardware and system processing power. Personal tools Create account Log in. If your connected device and the ConvertX are both work properly you will see activity on the level indicator bar which is blue in the illustration for 2.

Uploader: Sazshura
Date Added: 20 December 2016
File Size: 60.47 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 88249
Price: Free* [*Free Regsitration Required]

Plextor px m402u you don’t plextor px m402u anything. Device or resource busy” and you are using pulseaudio, disable pulseaudio’s control of the device, eg in pavucontrol Pulse Audio Volume Control under configuration, set the Cxxx Audio device to be off.

This page is notably incomplete. The audio device is going to have a name like: So that should work, right?

Plextor px-m402u driver windows 7

If your plextkr device and the ConvertX j402u both work properly you will see activity on the level indicator bar which is blue in the illustration for 2. The output of lsusb shows the device as:. However, many other apps have trouble. Another cool way to narrow down the information for any capture device and to show inputs and outputs The problem was caused by PulseAudio tieing up plextor px m402u resource ConvertX audio so it appeared busy to mplayer.

Recent Drivers  DRIVERS: BROTHER 9325CW

Retrieved from ” http: Please contribute by registering your plextor px m402u address and adding your knowledge to this page. By changing it from “Analog Stereo Input” to “Off” you allow mplayer to have access to alsa. You can p,extor might not be the correct term for it the sound card to the ConvertX audio input using module-loopback. There is a lot of information, plexxtor would help to narrow it down:.

Because you just combined everything so whatever else is playing through the card will get mixed and you will hear it or plextor px m402u will be captured if you are encoding. With the capture device working plextor px m402u both audio plextor px m402u video m402j mplayer then MythTV should be able to fully use the capture device.

See the partial mplayer error output:. Skip to end to see solution. It didn’t at first. While the firmware is included with the SDK, this firmware does not have an open license.

Video in mplayer but no audio.

It is better to use the method described in the VLC section where you can tell the software which input device to use for sound. I found plextor px m402u by using “pacmd list-sources”.

Recent Drivers  AMD A8-3800 TREIBER

Open KMPlayer and direct it m402y play from file: That area of the interface is empty. We made it so there was audio and video using VLC. I don’t know why this bothers mplayer and plextor px m402u vlc. It is just a matter of a proper configuration of MythTV back-end settings.

Plextor ConvertX PX-MU – Free Knowledge Base- The DUCK Project: information for everyone

The device was recognized in Mythbuntu immediately upon connection. This is an ugly hack. It has a plextor px m402u Linux SDK which has an open license. You might notice that sound lags behind the video depending on your hardware and system processing power.

There is latency when using the “hard wire” or “binding” hack. It would be better to specify which interfaces to mix specifically rather than just mixing them all. I couldn’t get this to work.